Anonymous
Not applicable
Nov 25, 2018
07:50 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 25, 2018
07:50 PM
Hello..
I just want to confirm if USB3014 SPI boot is possible in DQ32 mode..
According to datasheet, SPI port can't be used in DQ32 mode.. but I think boot from SPI is possible.. Am I right?
Best Regards,
Solved! Go to Solution.
1 Solution
Nov 25, 2018
09:07 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 25, 2018
09:07 PM
Hello,
Booting from SPI will be possible even though the firmware is used in DQ32 bit mode. Only upon the loading of firmware (with the GPIF II bus configured for 32-bits), the SPI port becomes unavailable.
Best regards,
Srinath S
1 Reply
Nov 25, 2018
09:07 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 25, 2018
09:07 PM
Hello,
Booting from SPI will be possible even though the firmware is used in DQ32 bit mode. Only upon the loading of firmware (with the GPIF II bus configured for 32-bits), the SPI port becomes unavailable.
Best regards,
Srinath S