Jan 24, 2017
04:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 24, 2017
04:14 AM
Dear Cypress,
I would like to customize Slave FIFO project by adding a input control pin.
Is it possible to initiate data transmission through GPIF from external device to the End-point when the rising-edge on one of the GPIF pins is appeared? Besides I need to transmit a strictly defined amount of data (probably I need to use counter in GPIF designer) and then I want to go back to waiting for the rising-edge state.
Which pin of GPIF for such input I should use?
Thank you!
1 Reply