Sep 01, 2020
05:00 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 01, 2020
05:00 AM
Hi
we have used an FX3 and Type a Male connector before, There we have swapped an RX and TX lines in the connector to Fx3.
This time we have used a Type A receptacle (Female), Here we have to swap the RX and TX pins or not?
This Type A receptacle is connected to the PC (Like UVC output) by male to male Cable.
Thanks.
Solved! Go to Solution.
1 Solution
Sep 02, 2020
03:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 02, 2020
03:05 AM
Hi,
The cable swaps RX and TX - so it need not be done on the device side.
Regards,
Hemanth
Hemanth
1 Reply
Sep 02, 2020
03:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 02, 2020
03:05 AM
Hi,
The cable swaps RX and TX - so it need not be done on the device side.
Regards,
Hemanth
Hemanth