Anonymous
Not applicable
May 31, 2016
08:11 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 31, 2016
08:11 AM
Hi
I have a problem when i use cyusb3014. I just want to transfer the data that generated by FPGA to PC. But the USB CINTROL CENTER receives the wrong data .
I use the sync slave fifo mode to communicate with the FPGA ,but when i transfer ox4000 and ox4001,the PC receives ox8000 and ox8001. The firmware that i downloaded is SDK build-in.
Does anyone ever meet this issue ?Is there any explanation to that ?
Thanks for any returns
Labels
2 Replies
Anonymous
Not applicable
Jun 08, 2016
01:46 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 08, 2016
01:46 PM
Hi,
This is strange. The only reason I can thnk of this is may be two data lines are interchanged in your schematic. Please check.
Regards,
- Madhu Sudhan
Jun 10, 2016
05:35 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 10, 2016
05:35 AM
Thanks for the answer. I have solved the problem. Thank u very much!