Attachments are accessible only for community members.
Oct 30, 2019
10:20 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 30, 2019
10:20 PM
HI,
I booted the FX3 code to transfer the data from u-port to p-port. FX3 is not detecting in the board. what might be the problem?
can anyone let me know about this.
I attached the code below, which was booted to 10 MP board.
Regards,
Aswini
Solved! Go to Solution.
1 Solution
Oct 30, 2019
11:10 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 30, 2019
11:10 PM
Hi Aswini,
We have programmed the image present in the debug folder of the attachment into FX3 Explorer kit and found to be enumerating.
Please check your board settings.
Regards,
Hemanth
Hemanth
1 Reply
Oct 30, 2019
11:10 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 30, 2019
11:10 PM
Hi Aswini,
We have programmed the image present in the debug folder of the attachment into FX3 Explorer kit and found to be enumerating.
Please check your board settings.
Regards,
Hemanth
Hemanth