- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I would like to use UART, but configure UART_RT S and UART_CT S as GPIO pins and only use UART_TX and UART_RX for my UART communication. Is this configuration possible?
When I try to configure the io matrix using the settings below, the firmware won't load.
CyU3PMemSet ((uint8_t *)&io_cfg, 0, sizeof(io_cfg));
io_cfg.isDQ32Bit = CyFalse;
io_cfg.s0Mode = CY_U3P_SPORT_INACTIVE;
io_cfg.s1Mode = CY_U3P_SPORT_INACTIVE;
io_cfg.useUart = CyTrue;
io_cfg.useI2C = CyFalse;
io_cfg.useI2S = CyFalse;
io_cfg.useSpi = CyTrue;
io_cfg.lppMode = CY_U3P_IO_MATRIX_LPP_DEFAULT;
io_cfg.gpioSimpleEn[0] = 0x0;
io_cfg.gpioSimpleEn[1] = 0x4000; // GPIO46 as simple
io_cfg.gpioComplexEn[0] = 0x0;
io_cfg.gpioComplexEn[1] = 0x8000; // GPIO47 as complex
Thanks.