Feb 15, 2021
03:35 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 15, 2021
03:35 AM
Is there any information about the reliability of SPI flash writes in the FX3 SDK Programming tools?
Is there a way to check if Programming is really correct if Programming success is achieved for SPI on the SDK?
Thanks,
Tetsuo
Solved! Go to Solution.
Labels
- Labels:
-
USB Superspeed Peripherals
1 Solution
Feb 15, 2021
06:33 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 15, 2021
06:33 PM
Hello Tetsuo-San,
Please refer to the following KBA to understand how to verify the flash contents after downloading the firmware into it using control center:
Best Regards,
Jayakrishna
Jayakrishna
1 Reply
Feb 15, 2021
06:33 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 15, 2021
06:33 PM
Hello Tetsuo-San,
Please refer to the following KBA to understand how to verify the flash contents after downloading the firmware into it using control center:
Best Regards,
Jayakrishna
Jayakrishna