- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear supports,
we want to use memory in normal operation F/W (280KB) + backup F/W (280KB).
During normal operation, only F/W (280KB) is used. If there is a problem with the F/W in the EEPROM, we would like to be able to boot to the Backup F/W.
(Only one of normal operation F/W or backup F/W)
Currently, we understood that the use of 256KB EEPROM 2EA in FX3 is the limit specification.
However, the EEPROM memory-related restrictions on the FX3 document have not been confirmed and the reason is unknown.
Please answer the following questions.
- 1. Reason for FX3 + 256K EEPROM 2EA limit specification
- 2. Whether FX3 and EEPROM can be used as follows.
1) FX3 + 512KB EEPROM 1EA
2) FX3 + 512KB EEPROM 2EA
Best Regards,
Tony Kim
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Hyundong,
It is not possible for FX3 Bootloader to address 1024KB (512KB x 2).
As mentioned on Page 13, Section 5.1 Features of the EZ-USB® FX3™/FX3S™ Boot Options:
It is only possible to address a max of 4 x 128KB (highlighted in green) EEPROM's which gives the total size that can be used as 512KB as shown in the image attached
So, you can either use 4 x 128KB or 2 x 256 KB EEPROM's (1 x 512KB EEPROM can be interfaced but we haven't tested it on our end).
Regards,
Yashwant