Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
OK
Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

USB Superspeed Peripherals

Anonymous
Not applicable
‎Jun 24, 2016 02:45 AM

FX3 - DataBus change

Hello ,

   

Is there any way to change DataBus GPIO's?

   

GPIF II only allow me to change data bus width (8/16/24/36 bits).

   

My point is to make 8bit bus but from GPIO 8:15 not 0:7 is there any way to change it? Or I need to use some hardware to swap bits? 

   

Regards,

   

Mikołaj

0 Likes
Reply
1 Reply
Anonymous
Not applicable
‎Jun 26, 2016 02:01 PM

Re: FX3 - DataBus change

Hi,

   

8 Bit databus only means 0:7.

   

15:8 cannot be used in this case.

   

Regards,

   

-Madhu Sudhan

0 Likes
Reply