Anonymous
Not applicable
Jun 24, 2016
02:45 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 24, 2016
02:45 AM
Hello ,
Is there any way to change DataBus GPIO's?
GPIF II only allow me to change data bus width (8/16/24/36 bits).
My point is to make 8bit bus but from GPIO 8:15 not 0:7 is there any way to change it? Or I need to use some hardware to swap bits?
Regards,
Mikołaj
1 Reply
Anonymous
Not applicable
Jun 26, 2016
02:01 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 26, 2016
02:01 PM
Hi,
8 Bit databus only means 0:7.
15:8 cannot be used in this case.
Regards,
-Madhu Sudhan