cancel
Showing results for 
Search instead for 
Did you mean: 

USB Superspeed Peripherals

Anonymous
Not applicable

I've been using the BulkLoop.exe that comes with the EZ-USB-FX-SDK to verify the hardware on a custom board with a CYUSB3014-BZXI device on it.

   

After searching around, the only technical documentation I found on it was a short Knowledge Base Article by Cypress. 

   

I was wondering if there was any other documentation out there, or if anybody else has used the tool.

   

A few details I'd like to know about the tool are:

   

- What's the transfer speed of the tool? (From using the tool, it seems to be about 0.0417 MB/sec, which seems a bit slow)

   

- What's the data that's being transferred? Is it a single byte? For incrementing, when it reaches 0xFF, does it overflow to 0x00 and restart?

   

Thanks!

0 Likes
Reply
1 Reply
Anonymous
Not applicable

Actually found the answer to my question. The cpp project can be found for bulkLoop.exe at <where SDK is installed>\.3\application\cpp\bulkloop\x86

0 Likes
Reply