Anonymous
Not applicable
Mar 04, 2013
06:13 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 04, 2013
06:13 AM
Hello,
Is there a driver or libusb app that does the same thing as the Cypress Control Center when it comes to USB RAM booting a blank device? I'd like to RAM boot my factory image then use that to flash the device with the production firmware. This way I can verify that the flash is readable/writeable.
If there is no such app, how does the Control Center send data over to an unprorgammed device? I could look at the traffic using a bus analyzer but I figured I'd ask first.
1 Reply
Anonymous
Not applicable
Mar 04, 2013
10:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 04, 2013
10:14 AM
Hi,
There is a Linux application from Cypress to download code into FX3 RAM.
Please download EZ-USB FX3 SDK v1.2.3 for Linux from the following webpage.
http://www.cypress.com/?docID=42387&dlm=1
Thanks,
Sai Krishna.