Aug 17, 2018
07:34 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 17, 2018
07:34 AM
Does FX3 require a low pulse at reset pin when powering up? Can I tie the reset pin directly (or through a pull-up resistor) to the corresponding supply rail if I do not need hard reset after power-up sequence is completed?
Solved! Go to Solution.
1 Solution
Aug 19, 2018
09:40 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 19, 2018
09:40 PM
Hi,
Yes,you can conncet the reset pin to CVDDQ rail with a pull-up resistor.
Regards,
Anil Srinivas.
3 Replies