cancel
Showing results for 
Search instead for 
Did you mean: 

USB Superspeed Peripherals

New Contributor II

I would like to try connecting an OmniVision OVM6211 camera module to the Denebola - CX3 Reference Design. If I were to make a custom daughter board for this camera, would the Denebola support it?

Many thanks

Hugo

0 Likes
Reply
1 Solution
Moderator
Moderator

Hugo,

Please refer question 11 from the following link:

CX3 Hardware: Frequently Asked Questions - KBA91295

It explains about making a custom sensor board for denebola RDK.

Regards,

Keerthy

View solution in original post

0 Likes
Reply
2 Replies
Moderator
Moderator

Hi Hugo,

If the daughter board of the image sensor that you make is compatible with the Denebola's MIPI camera board connector, then it should be fine.

Regards,

Hemanth

Hemanth
0 Likes
Reply
Moderator
Moderator

Hugo,

Please refer question 11 from the following link:

CX3 Hardware: Frequently Asked Questions - KBA91295

It explains about making a custom sensor board for denebola RDK.

Regards,

Keerthy

View solution in original post

0 Likes
Reply