- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I would like to try connecting an OmniVision OVM6211 camera module to the Denebola - CX3 Reference Design. If I were to make a custom daughter board for this camera, would the Denebola support it?
Many thanks
Hugo
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hugo,
Please refer question 11 from the following link:
CX3 Hardware: Frequently Asked Questions - KBA91295
It explains about making a custom sensor board for denebola RDK.
Regards,
Keerthy
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Hugo,
If the daughter board of the image sensor that you make is compatible with the Denebola's MIPI camera board connector, then it should be fine.
Regards,
Hemanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hugo,
Please refer question 11 from the following link:
CX3 Hardware: Frequently Asked Questions - KBA91295
It explains about making a custom sensor board for denebola RDK.
Regards,
Keerthy