- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using a J-Link to debug a CX3 Denebola board. It seemed to work fine when I had an application with only one thread. I am now working with two threads, and it's almost unusable. I have to restart the debugger constantly, or it just stops working. I also keep getting this message:
Debugger problem discovered:
The debugger has set two breakpoints at the same address
Whenever the program hits a CyU3PThreadSleep() function, I get the following error in the console:
ERROR: Bad JTAG communication: Write to IR: Expected 0x1, got 0x0 (TAP Command : 2) @ Off 0x5.
Can anyone tell me why the debugger is acting so terrible?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Can you please test this with the GpioApp Example (that uses two threads) and see if you are facing this issue?
Regards,
- Madhu Sudhan