- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
I'm configuring parameters of Sony image sensor in EZ USB suite. I can't find these parameters in the datasheet of Sony image sensor. Is there any way to calculate or get these parameters?
Thank you for your help.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The value of THS Prepare and THS Zero depends on the CSI clock.
Please first decide on the Hactive, Vactive, HBlanking, VBlanking, image data format. Image sensor settings should be available to configure these. Please contact the image sensor vendor.
Once you do this, you can use CX3 configuration tool to find out what the minimum and maximum values are, for CSI clock, THS Zero and THS prepare - then, you can configure the sensor accordingly.
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The value of THS Prepare and THS Zero depends on the CSI clock.
Please first decide on the Hactive, Vactive, HBlanking, VBlanking, image data format. Image sensor settings should be available to configure these. Please contact the image sensor vendor.
Once you do this, you can use CX3 configuration tool to find out what the minimum and maximum values are, for CSI clock, THS Zero and THS prepare - then, you can configure the sensor accordingly.
Regards,