cancel
Showing results for 
Search instead for 
Did you mean: 

USB Superspeed Peripherals

New Contributor

  Hi,Srinath S

                    I designed one IO board use CYUSB3014,the VDD and AVdd  need  1.2V.I use spx3819m5-1-2 chip apply 1.2V voltage and 500mA current.But after tested,I found that it didn't work.I use TLV62130RGT chip provide 1.2V 3A ,it work.I found that Icc need 200mA and Icc USB need 60mA on the datasheet.Is it static work power?

usb3.0外扩板-正面01-论坛.jpg 

双目3.0-CYUSB3014-0715.png

0 Likes
Reply
1 Solution
Moderator
Moderator

Hi,

The work current will not exceed the sum of Icc Core max and Icc USB max. It is the maximun value.

Regards,
Eddie

View solution in original post

0 Likes
Reply
3 Replies
Moderator
Moderator

Hi,

The work current will not exceed the sum of Icc Core max and Icc USB max. It is the maximun value.

Regards,
Eddie

View solution in original post

0 Likes
Reply
New Contributor

Hi,EddieZ_31:

                              I have checked the power.The 1.2V net only have some cap and the chip.But they costed much power.The test current much bigger than the datasheet's work current.What may cause the big power?

Regards,

Xibao 

0 Likes
Reply
New Contributor

Hi,Eddie:

        I doubt the chip welding may cause some problem.I will do some test though some test board.

Regards,

Xibao

0 Likes
Reply