- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Good day.
Now we use CX3 chip with optical sensor.
We found an interesting phenomenon.
When supply voltage of mipi CX3 block is 3.3 V, all good.
When supply voltage for mipi block is 1.8 V, no video sygnal from CX3.
Enumeration is good.
Please, tell me, what is it ?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Once you change the power supply of 3.3v to 1.8v, the SPI read operation could not complete correctly and CX3 could not boot from that.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is it possible to share your schematic design here or by private message?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The scheme is the same as in the "Denebola" debug board.
On the debug board "Denebola", we notice the same behavior.
There it is possible to moving of the resistor to select the voltage level for the power supply of the MIPI unit of CX3.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Once you change the power supply of 3.3v to 1.8v, the SPI read operation could not complete correctly and CX3 could not boot from that.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear,
Many thanks!