Mar 09, 2016
08:00 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 09, 2016
08:00 AM
Hi, We have a CX3, which is operating a Sony CMOS imager and utilising the MIPI data bus. We find that the MIPI reset pad is driven high at start-up and remains that way - apparently preventing MIPI transfers. The pad has a 10K pull-down but is otherwise unconnected. Is the MIPI reset somehow configured as an output, rather than an input? We cannot find any reference to setting its state in the data sheet.
Regards,
Terry
1 Reply