- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm curious if it's possible to receive 10 bit data as the upper 8 bits and stream the 8 bit data to the host.
Something like:
CyU3PMipicsiCfg_t parms = {
CY_U3P_CSI_DF_RAW10, /* CyU3PMipicsiDataFormat_t dataFormat */
2, ..
.. snip
// later
CyU3PMipicsiGpifLoad ( CY_U3P_MIPICSI_BUS_8 , CX3_IMAGE_BUFFER_SIZE )
The way I understand it is that this isn't possible, you'd receive the lower 8 bits. I'm not sure if there is a way though, wanted to check.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I dont't know if is it possible or not, I think that is not possible, the DMA takes a data of the image sensor and send it to the host.
but I think that is easier to configure the image sensor to 8bit mode.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Unfortunately this particular image sensor thus far seems to only send 10 bit data.