cancel
Showing results for 
Search instead for 
Did you mean: 

USB Superspeed Peripherals

Anonymous
Not applicable

Hi,

   

I accidentally flashed RAM instead of flashing SPI Flash from Cypress Control Center. I have a Denebola kit from e-con and now the camera doesn't stream image.

   

Can you please suggest a workaround?

   

 

   

Thanks!

0 Likes
Reply
3 Replies
Anonymous
Not applicable

I know RAM isn't supposed to effect the working state as the data should lose after a power cycle, but is there something else that could have caused the behavior? 

0 Likes
Reply
Anonymous
Not applicable

 The RAM will loose its contents right after a power cycle. You can just set the PMODE pins to F11 (OFF-ON-ON) and then power cycle. It should get you back to the bootloader.

   

 

   

Now to your original question: did you mean that the same firmware streams video when it was loaded from SPI Flash but not when it was loaded directly from RAM?

0 Likes
Reply
Anonymous
Not applicable

Ah, figured out the issue. It wasn't the RAM, some issue with the drivers.

   

I can boot from SPI. But the software doesnt even find the camera if I am on RAM, which I believe is the same mode as Boot mode.

0 Likes
Reply