Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
I accidentally flashed RAM instead of flashing SPI Flash from Cypress Control Center. I have a Denebola kit from e-con and now the camera doesn't stream image.
I know RAM isn't supposed to effect the working state as the data should lose after a power cycle, but is there something else that could have caused the behavior?
The RAM will loose its contents right after a power cycle. You can just set the PMODE pins to F11 (OFF-ON-ON) and then power cycle. It should get you back to the bootloader.
Now to your original question: did you mean that the same firmware streams video when it was loaded from SPI Flash but not when it was loaded directly from RAM?
