Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
OK
Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

USB Low-Full-High Speed Peripherals

Anonymous
Not applicable
‎Sep 09, 2008 04:47 AM

where do i configure the endpoints in the codes?

        hi, guys and gals.   
I have just started projects with FX2. I have some puzzles about the endpoints configurations. My puzzle follows below:   
For the high speed mode of FX2, the default descriptors provide 4 different interface configurations, and under each of the configurations, the features of the endpoints are different. So under such cases, where do i put the codes for the endpoints configuration in order to support multiple interfaces?   
   
thanks in advance.   
   
best regards,   
   
eric   
0 Likes
Reply
1 Reply
Anonymous
Not applicable
‎Apr 04, 2009 07:58 AM

Re: where do i configure the endpoints in the codes?

        you have to change the descriptor file and handling of set interface request...   
0 Likes
Reply