- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
In the FX2LP TRM,They have given that IFCONFIG.5 (output enable) Bit must not be set to 1 when IFCONFIG.7 is equal to 0 (external clock).what whould be the reason?
regards,
geetha.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Geethanjali,
When IFCLK source is configured to be external (IFCONFIG.7 = 0), the IFCLK pin acts as an Input pin. So, this pin cannot simultaneously drive the IFCLK. Hence, the output enable bit (IFCONFIG.5) should be set to 0 when the IFCLK source is external.
Best regards,
Srinath S
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Geethanjali,
When IFCLK source is configured to be external (IFCONFIG.7 = 0), the IFCLK pin acts as an Input pin. So, this pin cannot simultaneously drive the IFCLK. Hence, the output enable bit (IFCONFIG.5) should be set to 0 when the IFCLK source is external.
Best regards,
Srinath S