cancel
Showing results for 
Search instead for 
Did you mean: 

USB Low-Full-High Speed Peripherals

Anonymous
Not applicable
        We are trying to reconfigure the endpoints (only use EP2, EP4, EP6) instead of using the default configuration. We have already wrote to their respective registers to change that. However, file transfers don't seem to work. My question is, to reconfigure the endpoints what steps should be done besides writing to their registers. Do we need to address pktlen(reg 0x0A-0x11) and flush(reg 0x20)? I mean, what else should be considered in order to reconfigure the endpoints.   
   
Thank you.   
   
   
Jem   
0 Likes
Reply
0 Replies