- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have modified VID,PID in bulkLoop, a firmware routine in the development kit.
Then I added my modified VID and PID in the.INF file of the development kit
Drivers can be identified in device Manager after installation
But it's not recognized in the Control Center
There is also no way to read the modified VID and PID in CyConsole
Solved! Go to Solution.
- Tags:
- cypress fx2lp
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Can you please send the modified driver folder.
You can also try using the control center application present in the path: <Cypress installation directory>\EZ-USB FX3 SDK\1.3\application\c_sharp\controlcenter\bin\Release
I have added entries for VID and PID 0002/0002 as a test device to the cyusb3 driver and the control center application in the above path can recognize the device.
Thanks,
Yatheesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Can you please send the modified driver folder.
You can also try using the control center application present in the path: <Cypress installation directory>\EZ-USB FX3 SDK\1.3\application\c_sharp\controlcenter\bin\Release
I have added entries for VID and PID 0002/0002 as a test device to the cyusb3 driver and the control center application in the above path can recognize the device.
Thanks,
Yatheesh