cancel
Showing results for 
Search instead for 
Did you mean: 

USB Low-Full-High Speed Peripherals

New Contributor

I have modified VID,PID in bulkLoop, a firmware routine in the development kit.keil_01.jpg

Then I added my modified VID and PID in the.INF file of the development kit

inf01.jpg

inf02.jpg

inf03.jpg

Drivers can be identified in device Manager after installation

设备_01.jpg

But it's not recognized in the Control Center

usb_control_center.jpg

There is also no way to read the modified VID and PID in CyConsole

usb_console.jpg

usb_console_01.jpg

0 Likes
Reply
1 Solution
Moderator
Moderator

Hello,

Can you please send the modified driver folder.

You can also try using the control center application present in the path:  <Cypress installation directory>\EZ-USB FX3 SDK\1.3\application\c_sharp\controlcenter\bin\Release

I have added entries for VID and PID 0002/0002 as a test device to the cyusb3 driver and the control center application in the above path can recognize the device.

pastedImage_2.png

Thanks,

Yatheesh

View solution in original post

0 Likes
Reply
1 Reply
Moderator
Moderator

Hello,

Can you please send the modified driver folder.

You can also try using the control center application present in the path:  <Cypress installation directory>\EZ-USB FX3 SDK\1.3\application\c_sharp\controlcenter\bin\Release

I have added entries for VID and PID 0002/0002 as a test device to the cyusb3 driver and the control center application in the above path can recognize the device.

pastedImage_2.png

Thanks,

Yatheesh

View solution in original post

0 Likes
Reply