cancel
Showing results for 
Search instead for 
Did you mean: 

USB Low-Full-High Speed Peripherals

New Contributor

new to Cypress MCU, we have kail uVision assembly license, I need to use debug feature.  do I need a physical debugger? there are quite few documents on the cypress website, but I couldn't find an easy and simple answer of how to link the board to the software(PC).

Thank you

David Sun

0 Likes
Reply
1 Reply
Moderator
Moderator

The following application notes can help you.

AN58009 - Serial (UART) Port Debugging of EZ-USB® FX1/FX2LP™ Firmware | Cypress Semiconductor

http://www.cypress.com/documentation/application-notes/an42499-using-and-troubleshooting-keil-debugg...

You can use a RS-232 cable(if your PC has serial port) or a USB-to-UART cable(if your PC does not have serial port) to link your cy7c68013 board to the software(PC).

Roy Liu
0 Likes
Reply