USB low-full-high speed peripherals Forum Discussions

Hello,

I would like to change the VID/PID from the default value to a custom value.

Referring to chapter 3.1 of the Cypress USB-Serial Configuration Utility 2.0 User Guide, I changed the VID/PID in the driver's INF file.

When I tried to manually install the driver in that state, error occurred and I could not install it.

(Error: File hash is missing in the specified catalog file)

How can I use CY7C65211A with custom VID/PID?

Or is there another way to work with custom VID/PID without changing the INF file?

Regards

Please clarify if Ordering part number CY7C65215A-24LTXI is a typo or if Infineon plans to offer a CY7C65215A in a 24 pin package.

Page 1 of Data sheet for CY7C65215/CY7C65215A states:

Ordering part number
❐ CY7C65215-32LTXI
❐ CY7C65215A-24LTXI

Greg

I'm trying to upload a custom configuration to the CY7C65215A using the terminal based configuration utility in Linux

Ive generator an encrypted.cyusb file with the windows tool, and then used the decryption tool.

When I try to program theconfirmation file i get the following error

File opened successfully 

Bytes successfully read 

wrong silicon id

File stream closed

Hi,

Since the FX3 SDK is shared among the FX3 and FX2LP devices, I was wondering if the same applies for GPIF II designer. I'm totally new to the Cypress/Infineon ecosystem.

Zaher

Hello,

Is it necessary to take care of power-on sequence (timing, voltage, etc.) for VDDD and VBUS of CY7C65211A?
Please let me know if there is a power-on sequence.

Currently, after 5V is input to VBUS (pin 15), VDDD (pin 24) 3.3V rises 250μs after VBUS rises.
Is this a problem as a power-on sequence?

Regards.

Hi,

I'm transferring data from Tiva Microcontroller to FX2LP. I'm able to read 512 bytes through control center. But the data is repeated.

Kindly tell me how to solve data repetition problem

Thanks

Regards

Yazan Hussnain

Hi,

Can anyone help me with installation of cyusb suit for linux. I followed the step given in the readm-me file, but end up with no output.

I attached the images of command and their output given in the read-me file. Kindly check them and suggest the solution to the problem.

Thanks

Regards

Yazan

We have a product using a CY7C68013 FX2LP processor connected to a host via High Speed USB.  Currently the host is a tablet with an X86 processor running 64-bit Windows 10; the Cypress CyUSB driver is used to communicate with the CY7C68013 processor.  We have found that the USB3 version of the CyUSB driver works in our current system.  We are considering building a new host with an ARM64 variant processor running Windows 10.  We would need the equivalent of the USB3 version of the CyUSB driver for the ARM64 processor.  What options are available?