USB Low-Full-High Speed Peripherals

cancel
Showing results for 
Search instead for 
Did you mean: 
Ask a question

Recent discussions

Sort by:
ubs1
USB Low-Full-High Speed Peripherals
hi, After device re-enumeration, an user app downloads a new similar special purpose .hex file which slightly  different BULK endpoint configuration. ... Show More
yosuke
USB Low-Full-High Speed Peripherals
Hello I am using USBserialSDK(x64,windows) to control CY7C65211. But when CyGetDeviceInfoVidPid or CyGetDeviceInfo is called, this seem to have a ha... Show More
ubs1
USB Low-Full-High Speed Peripherals
hi, New to Fx2. How the FX2 native vendor command 0xA0 works and where is it stored?. How is it invoked?.  what is the I2C address of the (small) eepr... Show More
40dbun04
USB Low-Full-High Speed Peripherals
I'm trying to replicate the old NX2LP CY4618 RDK setup, but using the more modern FX2LP (specifically on the CY3684 DVK board). For those unfamiliar, ... Show More
Bhr_4752501
USB Low-Full-High Speed Peripherals
Hi, I need to know few details for the part CY7C65215A-32LTXI. 1.Current status of the part. 2.If active, then how long it will be supported? 3.Is the... Show More
abhishekps
USB Low-Full-High Speed Peripherals
Hi, I am using CY3689 DK for displaying video / image on VLC or MPC-HC player.I have taken "https://community.cypress.com/t5/Knowledge-Base-Articles/USB2-0-Camera-Interface-Using-FX2LP-and-Lattice-CrossLink-FPGA/ta-p/248972... Show More
leiwang0130
USB Low-Full-High Speed Peripherals
Hi, I have connected the CYUSBS234 with my PC.  I didn't see the "Cypress usb console windows driver" and "USB serial port(COM4)", only have the "USB-... Show More
r_shivakumar
USB Low-Full-High Speed Peripherals
Hi, I would like to know if there is a standard firmware with both I2C , GPIF interface and configuration utility available for EZ-USB® FX2LP CY7C6801... Show More
RaMa_4514991
USB Low-Full-High Speed Peripherals
The Crystal requirements for the FX2LP are clearly stated in the datasheet and several article on the community support site. • 24 MHz +/- 100 ppm• Pa... Show More
newbie
USB Low-Full-High Speed Peripherals
The card was not able to be read after changed the VID and PID settings using the "USB Serial Configuration Utility"  as below; from =  \VID_04B4&PID_... Show More
Board Information

USB Low-Full-High Speed Peripherals

Discussion forum regarding USB Low-Full-High Speed Peripheral topics.
Top liked authors