Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
Hi, I have a product that uses the Cy7C65640 TetraHub. In order to curb heat dissipation on the PCB, we decided to enable Fullspeed only. In our product, this works fine. But we are making a test for this PCB that connects to a computer in order to determine functionality. When the EEPROM is not connected, the default Highspeed mode works well with the PC. But, for some reason, even though the Fullspeed works with the product we wish to integrate it with, when connected to the PC, none of the downstream ports power up. Here's the Hex number that I feed the EEPROM: D200000000000088FF326432A0 Most of the number is default or recommended. Any help would be appreciated. Thanks, Matt