cancel
Showing results for 
Search instead for 
Did you mean: 

USB Low-Full-High Speed Peripherals

Anonymous
Not applicable
        I made a board with CY7C68024 and two memories NAND128W3A2 (from ST). It's designed according to a developement kit from Cypress. When I run a NX2LP Programmer Utility I can set type of memories etc. but if it try to create a FAT on chip, it's stopped immediately and show message "FAT32 formatting failed". I don't know what can I do whit this problem.   
Thank you very much.   
0 Likes
Reply
2 Replies
Anonymous
Not applicable
        i encountered the same thing as you said. My board is with Cy7c68033, and followed the Schematic in development kit CY3686. If your problem solved?   
0 Likes
Reply
Anonymous
Not applicable
        It means it is not able to write a configuration block with the data.... were you asked to enter the parameters i.e block size, number of page etc etc or did it just came up with the name directly???   
0 Likes
Reply