Anonymous
Not applicable
Feb 02, 2009
02:56 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 02, 2009
02:56 PM
I made a board with CY7C68024 and two memories NAND128W3A2 (from ST). It's designed according to a developement kit from Cypress. When I run a NX2LP Programmer Utility I can set type of memories etc. but if it try to create a FAT on chip, it's stopped immediately and show message "FAT32 formatting failed". I don't know what can I do whit this problem.
Thank you very much.
Thank you very much.
2 Replies
Anonymous
Not applicable
Jun 30, 2009
10:23 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 30, 2009
10:23 PM
i encountered the same thing as you said. My board is with Cy7c68033, and followed the Schematic in development kit CY3686. If your problem solved?
Anonymous
Not applicable
Jul 04, 2009
05:02 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 04, 2009
05:02 AM
It means it is not able to write a configuration block with the data.... were you asked to enter the parameters i.e block size, number of page etc etc or did it just came up with the name directly???