- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have designed a PCB for Cy7C65211 IC. In datasheet the default VID & PID is given and after connecting it to the PC the system throws error as "Device Descriptor Request failed" in the device manager. I tried to change the *.inf file, but need further assistance.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
- The problem could be possibly due to improper layout, do recheck that.
- Could you send a screenshot of the error message in the Device manager?
- Why are you trying to modify the *.inf file? If you are using the default VID,PID of Cypress, you need not modify it.
Regards,
Sananya
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
- The problem could be possibly due to improper layout, do recheck that.
- Could you send a screenshot of the error message in the Device manager?
- Why are you trying to modify the *.inf file? If you are using the default VID,PID of Cypress, you need not modify it.
Regards,
Sananya
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
thank you sanm,that was very much helpful..