cancel
Showing results for 
Search instead for 
Did you mean: 

USB Low-Full-High Speed Peripherals

Anonymous
Not applicable
        Hi,   
I am trying to transfer the high speed data in isochronous mode. I have Cy Console which I used to load the firmware into CY7C68013A.   
Now, In order to transfer the data , I want to use EZ-USB interface. where an option of isochronous data transfer is given(Iso Trans). But the button is inactive, so I cannot do the isochronous data transfer.   
I am using 1.7.0.2 Cyconsole.   
   
1. How can I do isochronous data transfer ?   
2. Is CyConsole what I am using is the latest one?   
3. Is is possible from EZ-USB interface to do isochronous data tranfer.   
   
Thanks.   
0 Likes
Reply
2 Replies
Anonymous
Not applicable
        By the way I was able to do data transfer in bulk transfer mode.   
0 Likes
Reply
Anonymous
Not applicable
        If iso trans button is inactive then it means your device does not have an isochronous endpoint... the application parses the descriptor and activates buttons that correspond to the device configuration... you can find streamer example in suiteusb which has a firmware with iso endpoints too... you can switch alternate settings in that firmware and then do isochronous transfer and check.... the cyconsole you have is the latest version....   
0 Likes
Reply