cancel
Showing results for 
Search instead for 
Did you mean: 

USB Low-Full-High Speed Peripherals

Anonymous
Not applicable

Hi!

   

We are trying to integrate the CCG3 (using the CY4531 kit) with an embedded controller (EC) so that we can interact with the PD-negotiation process. However, we can't find any documentation of the I2C interface or example on how to use the HPI interface. Are there any pointers for this?

   

Also, is there a guide for how to setup runtime debugging between PSoC Creator and the CY4531 kit? Should we use the SWD-port this and a MiniProg? Or can it be done using the USB port we use for uploading the firmware. Couldn't find any documentation around this.

   

Kind Regards

   

Christian

0 Likes
1 Reply
Anonymous
Not applicable

Hi!

   

Only EZ_PD configuration  utility and MiniProg3 can be completed on the development of CYPD3121?

0 Likes