cancel
Showing results for 
Search instead for 
Did you mean: 

USB Low-Full-High Speed Peripherals

Anonymous
Not applicable

Hello.

I am working on modifying the code in Cypress example AN61345 to transfer data from the Altera FPGA to the Host.

I can not send it, please post an example.

I would like you to upload the 8051 firmware source and the Altera FPGA source.

Thank you.

0 Likes
1 Solution
Anonymous
Not applicable

Hi,

I am attaching the fx2lp firmware source and fpga source used in An61345. Is this what you are asking?

Regards,

-Madhu

View solution in original post

0 Likes
3 Replies
Anonymous
Not applicable

Hi,

I am attaching the fx2lp firmware source and fpga source used in An61345. Is this what you are asking?

Regards,

-Madhu

View solution in original post

0 Likes
Anonymous
Not applicable

Hello. Madhu.

Thank you for answering my question.

I am working on an An61345 code, but it will not work.

Can I use the Slave FIFO mode in the FPGA to load the source that transfers data to the PC?

Best Regards,

Sang gyu, Park

0 Likes
Anonymous
Not applicable

Hi,

You can load the source into FX2LP using I2C or USB interfaces. If your FPGA supports I2C slave, you can use it to load the source into FX2LP via I2C interface., (FX2LP has a I2C master)

For I2C boot, please refer: http://www.cypress.com/documentation/application-notes/an50963-ez-usbr-fx1tmfx2lptm-boot-options

Regards,

-Madhu

0 Likes