Jul 14, 2021
07:31 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 14, 2021
07:31 PM
The Crystal requirements for the FX2LP are clearly stated in the datasheet and several article on the community support site.
• 24 MHz +/- 100 ppm
• Parallel resonant
• Fundamental mode
• 500 μW drive level
• 12 pF (5% tolerance) load ca
Does Cypress have any recommendations for using a current limiting resistor to reduce the 500uW drive level requirement?
Solved! Go to Solution.
Labels
1 Solution
Jul 14, 2021
11:12 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 14, 2021
11:12 PM
Hi,
Kindly refer to the following KBA:https://community.cypress.com/t5/Knowledge-Base-Articles/Using-a-Lesser-Drive-Level-Crystal-with-EZ-...
Regards,
Mallika
1 Reply
Jul 14, 2021
11:12 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 14, 2021
11:12 PM
Hi,
Kindly refer to the following KBA:https://community.cypress.com/t5/Knowledge-Base-Articles/Using-a-Lesser-Drive-Level-Crystal-with-EZ-...
Regards,
Mallika