Jun 07, 2018
03:55 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 07, 2018
03:55 AM
Hello,
I am performing fx2lp booting in c2load mode.eeprom used is not write protected means the WP pin is connected to ground(same as fx2lp dvk),it means i can load firmware to eeprom.but after firmware is loaded to eeprom,i want to do write protected to eeprom.how can i do this?
regadrs,
geetha.
Solved! Go to Solution.
1 Solution
Anonymous
Not applicable
Jun 08, 2018
05:21 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 08, 2018
05:21 AM
1 Reply
Anonymous
Not applicable
Jun 08, 2018
05:21 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 08, 2018
05:21 AM