- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I get spt file from .hex with cypress center
Parsing a script (.spt) with cypress center the device working
so i package it with cyusb.inf cyusb.sys syusb.cat(sign file) , hoping the 68013 load it after it is connect to PC\
but something goes wrong ,even though bulkout and bulkin apare in the cypress center after my device connect,when i try to transfer data with them it fails eveytime.
so what is the problem?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please refer section page 8 of the attached link to know how to " Execute a script at start-up"
http://www.cypress.com/file/145261/download
Please clarify what goes wrong?What is the behavior of the device? Does the device gets programmed with the scripts?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please refer section page 8 of the attached link to know how to " Execute a script at start-up"
http://www.cypress.com/file/145261/download
Please clarify what goes wrong?What is the behavior of the device? Does the device gets programmed with the scripts?