cancel
Showing results for 
Search instead for 
Did you mean: 

USB Low-Full-High Speed Peripherals

Anonymous
Not applicable

If I have an FX2LP in "ports" mode (IFCONFIG[1:0] = 00), can I programmatically control the CTL1 & CTL2 pins? Or are those pins only accessible in slave-FIFO and GPIF modes?

   

Thanks!

   

Chris

0 Likes
Reply
2 Replies
Anonymous
Not applicable

Never mind, I found the answer; the register is GPIFIDLECTL, which I had ignored because I assumed it was only relevant to GPIF mode. But it works fine in ports mode too. Sorry for the noise.

   

Chris

Anonymous
Not applicable

Thanks for updating the thread Chris.

   

-Sai Krishna.

0 Likes
Reply