- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have no experience with cypress and want to program a USB FX2LP CY7C68013A. I read that with EZ-USB FX2LP USB2.0 Develope Board Logic Analyzer Module bought on ebay can be programmer. I dont know if there is an adapter for CY7C68013A with 56 pins or in what way do the connections between CY7C68013A pins and the programmer. I would also like to know if are some specific pins which must be used or if they are all chip pins.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
There are 2 methods to program the FX2LP.
a) Download from USB - The code can be loaded onto FX2LP from the USB interface itself.
b) Boot from EEPROM- Once code development is complete, the binaries can be loaded onto EEPROM and then system can boot from the EEPROM.
The document below has the details:
http://www.cypress.com/documentation/application-notes/an50963-ez-usb-fx1-fx2lp-boot-options
I am not sure which is the programmer you are referring to on ebay, pass the link and i can do a quick check.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If I have a circuit with a fx2lp and eeprom working. I can copy the information from eeprom and write in a new eeprom, fx2lp works as the original circuit?