- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am working on USB device, which receives data from Windows PC over USB and Tansmit data over ethernet lines to slave devices. My end points configuration is
EP 2 - AUTOOUT, 2x Bulk, 512 Bytes
EP4 - AUTOOUT, 2x Bulk, 512 Bytes
EP6 - AUTOIN, 2x Bulk, 512 Bytes
EP8 - AUTOIN, 2x Bulk, 512 Bytes
My Cypress Chip is working in Slave FIFO Mode and Spartan 6 FPGA is acting as master. i am able to receive data on my host pc from usb device via end point 6 and 8 without any problem and i am able to transmitt data from host pc to usb device via end point 4 without any issue. Rx and Tx are working independently without any problem.
But when i am doing bulk transfer on end point 2, the communication stops after 130 transmission of 512 bytes chunk.
I have check data on USB Analyzer. I am not getting acknowledgement of my last transmitted packet. I have attached signals received on chipscope.
Please help me solve this issue.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Could you please create a tech support case regsrding the issue that you are seeing.
Also please attach all the necessary project files to the case.
Thanks,
sai krishna.