cancel
Showing results for 
Search instead for 
Did you mean: 

USB Low-Full-High Speed Peripherals

Anonymous
Not applicable

How can I tell that the CY7C68013 is enumerated?  I need to send notification to the hardware (via firmware) that the USB cable has been unplugged.

0 Likes
Reply
1 Reply
Anonymous
Not applicable

In a self powered design you have to monitor the VBus for correct USB behavior: Take a look into the Cypress AN15813 for details. Doing this, you have an information about the cable plugged or not. You can also watch the "SetConfiguration" Command, but this is only called at Plug-In and successfull enumeration by teh host. AFAIK there is no software command after removing the USB cable.

0 Likes
Reply