cancel
Showing results for 
Search instead for 
Did you mean: 

USB Low-Full-High Speed Peripherals

Anonymous
Not applicable

Hi, I have Cypress CY7C65215-32LTXIT device. I would like to configure my device communication as I2C on GNU/LINUX. But I don't do this. There is "USB-Serial Configuration Utility" for Windows but not Linux.  Do you know "Configuration API" or software(utility) on Linux  for CY7C65215-32LTXIT?

0 Likes
4 Replies
Anonymous
Not applicable

Hi,

   

As of now there is no configuration utility available for linux. You need to configure the device in linux but afterwards can use the configured device with a linux machine.

   

Regards,

   

-Madhu Sudhan

0 Likes
hesoc_3988631
New Contributor

HI, mady:

          Here are some of my needs could you tell if it's doable?

           1.   working as Two I2C

           2.   need switch master and slave in application under Linux

           3.  need to Configuring  this using Linux API not windows tool. (one time configuration might ok, but afterwards all Linux)

           4.  is that possible to red and write some Flash area by I2C side. not USB side.

CY7C65215-32LTXIT Linux Configuration Tool

CY7C65215 - Programming the configuration flash

Thanks!

0 Likes
Anonymous
Not applicable

Hi,

   

Firstly, thank you for answering my question. I opened the case about this issue. The Cypress answered that you could generate a .cyusbd file on windows, which could be flashed in the device in Linux using one other utility. But which utility should I use for flashing device on Linux and how can I do this? I use the device as a usb device.

   

Best Regards,

0 Likes
Anonymous
Not applicable

Great Post

0 Likes