i have a CY7C65213-32LTXI chip on my custom board.
It should work as a UART interface,
but when i connect to it it says it is in CY_TYPE_MFG mode and no UART SetFunction or even GetConfig will work.
- I tried to program it with "USB Serial Configuration Utility.exe" but it wont change the Device type...
- Do i need to program the Flash or what?
- even if, where can i get a binary to flash??
- or is it just the wrong driver???
tnx in advance
Can you create a tech support case at https://secure.cypress.com/myaccount/?id=25&createCase=techSupport with screenshot of "USB Serial Configuration Utility.exe" when device is connected?
Ok, heres the screens from the Config tool. This is using a little Evalboard not the custom boar but i have the same Error with the API that i cannot get the uart config or even set.
many tnx in advance