- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1. If we use miniprog3 to read hex from CY7C65211, Does hex file contain "FW + Setting" or "Setting" only?
2. Now we face a problem.
Because we program hex file ( read from chip : version is 1.0.3.78 ) to CY7C65211 using miniprog3 before PCBA.
After PCBA , we use the USB-Serial Configuration Utility to check, we found the FW version is 1.0.3.64
is there any side effects ??
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Ivan,
Theortically CY7C65211 is a fixed-firmware part. We do not release Hex file and programming spec to regular customers. You can contact the Cypress Window that released the HEX file to you for release note and fw change list.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please give me the fw change list.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Ivan,
Theortically CY7C65211 is a fixed-firmware part. We do not release Hex file and programming spec to regular customers. You can contact the Cypress Window that released the HEX file to you for release note and fw change list.