Jul 29, 2020
03:13 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 29, 2020
03:13 AM
The power-on sequence is described in the data sheet.
(Within 10ms between VDD and VDDIO1)
What failure mode will occur if this specification is violated?
Thanks,
Tetsuo
Solved! Go to Solution.
1 Solution
Jul 30, 2020
08:04 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 30, 2020
08:04 PM
Hi Tetsuo-san,
The most common scenario is that the device could not enumerate correctly after reset.
Regards,
Eddie
4 Replies
Jul 30, 2020
08:04 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 30, 2020
08:04 PM
Hi Tetsuo-san,
The most common scenario is that the device could not enumerate correctly after reset.
Regards,
Eddie
Aug 04, 2020
01:41 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 04, 2020
01:41 AM
Eddie-san,
Thank you for your answer.
I understand that it will not suffer serious damage such as device destruction. Is it correct?
Thanks,
Tetsuo
Aug 04, 2020
03:10 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 04, 2020
03:10 AM
Hi Tetso-san,
No, it will not cause device destruction.
Regards,
Eddie
Aug 05, 2020
01:50 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 05, 2020
01:50 AM
Eddie-san,
Thank you very much.
I understand.
Thanks,
Tetsuo