cancel
Showing results for 
Search instead for 
Did you mean: 

USB Low-Full-High Speed Peripherals

Siva
New Contributor II

Hi can anyone, help me with blinking led code for  CY7C63813(low speed USB 2.0 peripheral controller)   psoc designer 

0 Likes
1 Solution
PranavaYN
Moderator
Moderator

Hi,

You can toggle an LED by connecting it to a GPIO and driving GPIO in main.c by configuring it as output pin in PSoC Designer and writing to PxData register where "x" is the port number.

You can use timer to have some delay between toggling. MSTimer user module datasheet - https://www.cypress.com/documentation/user-module-datasheets/user-module-datasheet-1-millisecond-int...

 

Best regards,
Pranava

View solution in original post

0 Likes
1 Reply
PranavaYN
Moderator
Moderator

Hi,

You can toggle an LED by connecting it to a GPIO and driving GPIO in main.c by configuring it as output pin in PSoC Designer and writing to PxData register where "x" is the port number.

You can use timer to have some delay between toggling. MSTimer user module datasheet - https://www.cypress.com/documentation/user-module-datasheets/user-module-datasheet-1-millisecond-int...

 

Best regards,
Pranava

View solution in original post

0 Likes